Riser Feet for the xTool M1 Riser and Honeycomb

Installation

You'll need a 6" (150mm) phillips screwdriver and some tape.

STEP 1. Remove the original rubber feet and insert the Screw Down Riser Feet. 

STEP 7. Screw the two shorter clamps to the inside bottom rail of the riser base, behind the last grid stop screw. Screw the two taller clamps to the outside edge of the bottom rail, near the front. The longer of the two taller clamps goes on the right. The exact location of these is not very important, just towards the front.

STEP 2. Once installed, assemble and re-align your Riser Base by setting the M1 on top temporarily to make sure everything is square. Place tape on your surface so you can ensure proper alignment later.

STEP 3. Mark the hole locations from above with a pencil or marker (You'll need to temporarily remove the top rubber covers to do this). Be careful not to move the riser base. Check your tape for alignment after each corner.

STEP 4. Set the Riser base aside and pre-drill the holes if desired. Move your Riser Base back to your marked location.

STEP 5. Do not fully tighten down the screws yet. Use the provided screws to attach the feet to your table, workbench, cart, or piece of portable wood - leave the screws loose. The screw holes are slotted to account for inaccuracies in drilling the holes. The layout should look like this:

STEP 6. Place the Riser Base onto the screw down feet. Fully tighten the screws.